International Standard
ISO 5686-2:2024
Polygonal turret interface with flat contact surface — Part 2: Receivers of type F, H, A and X for shanks of type F, H and A
Reference number
ISO 5686-2:2024
Edition 1
2024-10
© ISO 2025
Preview
недоступно на русском языке
Опубликовано (Версия 1, 2024)

ISO 5686-2:2024

Язык
Формат
CHF 199
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

This document specifies the dimensions of polygonal taper receivers with flat contact surface (PTI). These receivers are the machine-side part of the interface to the (in cutting process non-rotating) tool carrier of machine tools (e.g. turret lathes, turning centres).

This document specifies four types of machine-side interface types, which differ at the face contact. The bores for receiving the tool shanks themselves are designed identically for all types.

—     Receiver type F has one hole for the coolant supply (F = fluid); PTI-F type tool holder can be installed in 0°- and 180°-position.

—     Receiver type H has a primary coolant hole for the main supply and a secondary coolant hole for an intermediate tool position on the face contact (H = half). For PTI type H holders an installation position offset by 180° is not possible.

—     Receiver type A has one hole on the face contact for the primary coolant supply and one additional hole for supplying the tool holder (driven tool) with sealing air (A = air). Two more bores allow the installation of PTI-A holders with spring-type straight pin in 0°- and 180°-position.

—     Receiver type X has a primary coolant hole for the main supply and a secondary coolant hole for an intermediate tool position on the face contact. In addition, the type X receiver has one hole for supplying the tool holder (driven tool) with sealing air and two bores for the 0°- and 180°-position of the spring-type straight pin of PTI-A holders.

Общая информация

  • Текущий статус
     : Опубликовано
    Дата публикации
     : 2024-10
    Этап
    : Опубликование международного стандарта [60.60]
  • Версия
     : 1
  • Технический комитет :
    ISO/TC 29/SC 9
    ICS :
    25.060.20 
  • RSS обновления

Жизненный цикл

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития

9
Индустриализация, инновации и инфраструктура

Появились вопросы?

Ознакомьтесь с FAQ

  2. Интернет-магазин
  3. Интернет-магазин
  4. ТК
  5. ISO/TC 29/SC 9
  6. ISO 5686-2:2024