Reference number
ISO 22621-6:2010
© ISO 2024
ISO 22621-6:2010
Plastics piping systems for the supply of gaseous fuels for maximum operating pressures up to and including 2 MPa (20 bar) — Polyamide (PA) — Part 6: Code of practice for design, handling and installation
Edition 1
2010-04
Withdrawn
Withdrawn (Edition 1, 2010)

Abstract

ISO 22621-6:2010 specifies a code of practice dealing with polyamide (PA) piping systems, intended to be buried outside buildings and used for the supply of gaseous fuels.

It is applicable to mains and service lines, the components of which are prepared for jointing by scraping and/or machining, and gives instructions for the design, storage, handling, transportation, laying conditions and fusion quality control of PA pipes and fittings up to and including 250 mm outside diameter, as well as subsequent joint testing, backfilling, pipe system testing, commissioning and decommissioning.

The jointing methods covered by ISO 22621-6:2010 are butt fusion jointing and electrofusion jointing.

General information

  • Status
     : Withdrawn
    Publication date
     : 2010-04
    Stage
    : Withdrawal of International Standard [95.99]
  • Edition
     : 1
    Number of pages
     : 21
  • Technical Committee :
    ISO/TC 138/SC 4
    ICS :
    75.200  83.140.30 
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. 75
  6. 75.200
  7. ISO 22621-6:2010