Reference number
ISO 4386-1:2019
International Standard
ISO 4386-1:2019
Plain bearings — Metallic multilayer plain bearings — Part 1: Non-destructive ultrasonic testing of bond of thickness greater than or equal to 0,5 mm
Edition 4
2019-04
Read sample
ISO 4386-1:2019
77223
Published (Edition 4, 2019)

ISO 4386-1:2019

ISO 4386-1:2019
77223
Language
Format
CHF 63
Convert Swiss francs (CHF) to your currency

Abstract

This document specifies an ultrasonic testing method for determining bond defects between the bearing metal and the backing. The test can be performed on metallic multilayer plain bearings consisting of steel- or copper-based material backings lined with bearing metal based on lead and tin, with layer thicknesses greater than or equal to 0,5 mm. For cast iron backings, this document is applicable with restrictions.

The ultrasonic signal reflected by the bond interface between the bearing metal and the backing is used to determine bonding defects.

Ultrasonic testing is not possible on edge zones of sliding surface, flange sides, joint areas, oil holes, grooves, etc. in a range of less than half the diameter of the ultrasonic probe because of undefined reflections. The same applies to bearings with dovetail keying grooves at the bond. Ultrasonic testing of bond does not apply along the edges of the dovetails.

Evaluation of the bond on the visible transition from the backing to the bearing metal (on end faces or joint faces) is only practicable by the penetrant testing method specified in ISO 4386-3.

This document only describes in detail the pulse-echo method. Within the meaning of this document, the ultrasonic method only permits a qualitative evaluation of the bonding and not a quantitative determination of the bond strength. The ultrasonic bond test differs only between bond and bond defect.

General information

  •  : Published
     : 2019-04
    : Close of review [90.60]
  •  : 4
     : 9
  • ISO/TC 123/SC 2
    21.100.10 
  • RSS updates

Got a question?

Check out our Help and Support