Draft
International Standard
ISO/DIS 1938-1
Geometrical product specifications (GPS) — Dimensional measuring equipment — Part 1: Plain limit gauges of linear size
Reference number
ISO/DIS 1938-1
Edition 2
© ISO 2024
Draft International Standard
Under development
This Draft International Standard is in the enquiry phase with ISO members.
Will replace ISO 1938-1:2015

Abstract

ISO 1938-1:2015 specifies the most important metrological and design characteristics of plain limit gauges of linear size.

ISO 1938-1:2015 defines the different types of plain limit gauges used to verify linear dimensional specifications associated with linear size.

ISO 1938-1:2015 also defines the design characteristics and the metrological characteristics for these limit gauges as well as the new or wear limits state Maximum Permissible Limits (MPLs) for the new state or wear limits state for these metrological characteristics.

In addition, ISO 1938-1:2015 describes the use of limit gauges. It covers linear sizes up to 500 mm.

General information

  • Status
     : Under development
    Stage
    : DIS registered [40.00]
  • Edition
     : 2
  • Technical Committee :
    ISO/TC 213
    ICS :
    17.040.40 
  • RSS updates

Life cycle

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. 17
  6. 17.040
  7. 17.040.40
  8. ISO/DIS 1938-1