Draft
International Standard
ISO/DIS 2507
Thermoplastics pipes and fittings — Vicat softening temperature: General test method and test conditions for Vinyl chloride - based (PVC-U, PVC-C, PVC-Hi) and Acryl nitrile - based (ABS, ASA) pipes and fittings
Reference number
ISO/DIS 2507
Edition 3
© ISO 2024
Draft International Standard
Under development
This Draft International Standard is in the enquiry phase with ISO members.
Will replace ISO 2507-1:1995 | ISO 2507-2:1995 | ISO 2507-3:1995

Abstract

The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.

General information

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goals

9
Industry, Innovation and Infrastructure
6
Clean Water and Sanitation

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. TC
  5. ISO/TC 138/SC 5
  6. ISO/DIS 2507